Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
System Startup
1. Remove all packing materials.
2. Place the computer on a stable surface.
3. Insert the battery and make sure it is locked in position.
4. The AC/DC adapters can be stored in the stand supplied, but can only be
orientated one way as indicated in the picture on the right. Insert the adapters
with the open end for the power cord facing the 280W logo. Do not use a
single AC/DC adapter to power the system (see
5. When first setting up the computer use the following procedure (as to
safeguard the computer during shipping, the battery will be locked to not power
the system until first connected to the AC/DC adapters and initially set up as
below):
• Attach the AC/DC adapter cords to the DC-In jacks on the rear of the com-
puter then plug the AC power cords into an outlet, and connect the AC power
cords to the AC/DC adapters and the battery will now be unlocked.
6. Use one hand to raise the lid to a comfortable viewing angle (do not exceed 130
degrees); use the other hand (as illustrated in
the computer (Note: Never lift the computer by the lid).
7. Press the power button to turn the computer "on".
System Software
Your computer may already come with system software pre-installed.
Where this is not the case, or where you are re-configuring your com-
puter for a different system, you will find this manual refers to Micro-
soft Windows 10.
Intel® Optane™/RAID Support
Note that your system can be set up as a RAID OR to support Intel®
Optane™, but it cannot be set to support both systems. You need to
setup Intel
Optane™ or RAID before installing your Windows 10 operating system (see
®
4
Adapter Notes on page
3).
1) to support the base of
Figure
Adapter Stand
130 °
Opening the Lid /
Dual AC/DC Adapt-
&
page 5
Figure 1
Computer with
ers Plugged-In
page
7).
Werbung
Inhaltsverzeichnis
Fehlerbehebung
