Mounting Wheels For Earthmoving Machines With A Side Ring; Tyre Grooving; Stop Command And Emergency Procedure - Corghi MONSTER AGTT Betriebsanleitung

MOUNTING WHEELS FOR EARTHMOVING
MACHINES WITH A SIDE RING
Position the tyre in the loading area� Move the turntable with the locked rim, centring
it correctly� If necessary, turn the turntable, which may help the complete insertion of
the rim�
Mount the second bead using the bead breaker tool�
Insert the side ring and lock it with the specific lock ring (Fig� 47)�
If the tyre is tubeless, insert the sealing ring between the rim and the side ring�
If the wheel has an inner tube, insert it in the tyre prior to mounting, stretching it out
uniformly inside the tyre, slightly inflated�

TYRE GROOVING

After positioning the wheel with the rim on the turntable, set the rotation speed to mini-
mum using the specific switch (control 6 fig�13)�
N�B� The grooving operation is done from the wheel entry side (clockwise rotation)�
N�B� The grooving speed turns only clockwise�
STOP COMMAND AND EMERGENCY
PROCEDURE
The machine is powered by turning the main switch (Fig� 18) located on the electric
system box to zero�
Pressing the stop button makes all controls stop TEMPORARILY (20 seconds)� "STOP" will
appear on the display� After 20 seconds, the machine will return to the Stand-By position;
if commands are pressed, "Stop" will remain displayed flashing until they are released�
All the commands located on the control lever are interrupted by releasing the command
itself (dead-man switch)�
Exceptions are the commands relative to the Side To Side and bead breaker disc/tool
tangency functions� When performing the Side To Side command, the procedure can be
UK
interrupted by pressing any command on the control lever�
WARNING
If the by-pass coil (YV1) or the electronic card have problems, the wheel can still be
released from the turntable� Set the switch X (fig�48), which is normally set to 0, to pos� 1
(Stand-By off function)� At this point, the control unit motor will always be running� Use a
screwdriver on the by-pass coil (fig�49) and then on the respective solenoid valves (fig�50)
to make the machine operate at emergency speed� In this way, the locked wheel can be
released� Then contact technical assistance�
Operator's manual MONSTER AGTT 59