With Windows® Me - Brother P-touch 9200DX Kurzanleitung

D In the Add New Hardware Wizard dialogue box that
confirms that installation is complete, click the Finish
button.
E In the USB Connection dialogue box that confirms that
installation is complete, click the Finish button.
F Remove the CD-ROM from the computer, select "Yes,
I want to restart my computer now.", and then click
the Finish button to restart the computer.
With Windows® Me:
The software and printer driver installation should be per-
formed in the following order:
(1) P-touch Editor Version 3.1
(2) USB printer driver
(1) P-touch Editor Version 3.1 installation
Make sure that the P-touch is not connected to the
computer, otherwise P-touch Editor Version 3.1
may not be installed correctly.
1 Install P-touch Editor Version 3.1 according to the
procedure described in P-touch Editor Version 3.1
Installation on pages 22 through 23.
2 After installation of P-touch Editor Version 3.1 is
finished, install the USB printer driver as described
below.
14
(2) USB printer driver installation
3 In the Port Selection dialogue box that appears, select
"USB", and then click the Next button.
4 The USB message dialogue box appears. (Do not
click the Finish button.)
5 Connect the P-touch to the computer using the
enclosed USB interface cable, and then turn on the P-
touch. (refer to "Connecting the interface and power
supply cables" on page 3.)
6 After the Found New Hardware dialogue box is briefly
displayed, the first Add New Hardware dialogue box
appears. Put a check mark beside "Specify the
location of the driver [Advanced]", and then click the
Next button.