Troubleshooting / Faq - Bushnell 119932C Bedienungsanleitung

After the photos are copied to your hard drive, you can disconnect the Prime Trail
Camera. (On Mac computers, drag the "disk" that appeared on your desktop when
the camera was connected into your Trash to "eject" it before disconnecting.)
.jpg standard files from the Prime Trail Camera may be viewed and edited with any
photo software you choose to use. The .avi video files may be viewed with Windows
Media Player (version 7 or later) as well as other video playback programs that may
have been supplied with your computer, or are available online.

TROUBLESHOOTING / FAQ

Camera takes continuous images of no subject
A camera has what is known as a "false trigger" if the PIR sensor thinks that there
is motion and heat in front of the camera lens when there is no subject in the image.
These "False Triggers" are the result of placing the camera in an environment where
there is motion associated with tree branches creating motion in front of the camera
or an area where there is high heat in the foreground and any motion from wind
could set off the camera. Setting a camera up over water is also a potential cause
for this issue. To remedy this situation:
Try moving the camera to an area that does not have any of these issues or try
1.
changing the sensor level on the menu settings.
If the camera continues to take images when there is no subject in them, try
2.
placing the camera in an inside environment and aiming at a location where there is
no motion.
If the camera continues to show issues, then there is probably an electronic
3.
component issue. If this is the case, please contact our customer service to send
the camera back for repair.
Battery life is shorter than expected
Battery life will vary with operating temperature and the number of images taken
1.
over time. Typically, the Prime Trail Camera will be able to capture several
thousand images before the batteries die.
Check to make sure you have used new alkaline or lithium batteries. Bushnell
recommends using Energizer® Lithium AA batteries in your
Prime Trail Camera to obtain maximum battery life.
2.
Make sure that the power switch was turned to the "On" position and that the
3.
camera was not left in "AIM" mode while in the field.
Make sure that you are using a good quality name brand SD card in your camera.
4.
Bushnell recommends SanDisk® brand SD Cards up to 32GB. Our experience
indicates that poor quality SD cards can sometimes reduce your Prime Trail
24
The