mundoclima MUPO-09-H10 Bedienungsanleitung Und Installationshandbuch Seite 60

B. Heating (Optional for Heating Function Unit only)
Press MODE button repeatedly until the LED of HEAT operation lights up.
Press UP/DOWN button to set the temperature higher than the room
temperature. The fan speed can also be set.
Note: The drainage hose should be attached to the unit for continuous
operating.
C. Ventilation
Press MODE button repeatedly until the LED of FAN operation lights
up.
In ventilation mode the room air is circulated, but not cooled.
Press SPEED button repeatedly to select the fan speed as desired.
D. Dry
Press MODE button on the control panel or remote control, the LED
of DRY operation lights up. The fan speed is unable to select. User
should connect the hose to the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot
be selected.
E. Sleep mode (this function can only be used with a remote
control)
The sleep mode can be activated when in cool mode
In cool mode:

After 1 hour the preset temperature is increased by 1°C, after another
hour the preset temperature will again be increased by 1°C.
60