Sony WLA-NWB1 Bedienungsanleitung Seite 12

 T ip
You can control the volume on the Bluetooth receiving device.
Notes
 Depending on your Walkman, when the Walkman is in Sleep status, you may
need to keep pressing the play button in order to play back.
 Even if you control the volume on the Walkman, sound from the Bluetooth
receiving device will not change. If the Bluetooth receiving device is supported by
AVRCP (Vol +/-), you can control its volume. (For more details, see page 13.)
 When this unit establishes the Bluetooth connection with the Walkman, AVLS
(Automatic Volume Limiter System) is deactivated and beep sounds are not
emitted.
 If this unit and the Bluetooth receiving device become out of range and
the Bluetooth connection terminates, repeat the procedure from step 1.
Note, however, that if the unit and the Bluetooth receiving device come into
connectable range again within about 10 minutes, Bluetooth connection will be
reestablished automatically.
 When you listen to FM radio on a Walkman with a built-in FM tuner through
the Bluetooth receiving device, make sure to connect the headphone to the
Walkman, as the headphone cord works as an antenna, otherwise FM signals
cannot be received.
 If the recording level of audio data on the Walkman is too high, the output sound
quality from the Bluetooth receiving device, may not meet the user customized
settings, e.g., "Equalizer" etc.
 Playback through a Bluetooth connection may cause noise, sound break, or
playback speed change depending on the location and the usage (page 14).
About the MODE switch
You can select the sound quality or wireless communication stability preferentially.
MODE 1: Sound quality takes priority.
MODE 2: Reception stability takes priority.
Notes
 When you set the MODE switch to MODE 1, and experience interference from
other wireless communication devices or sound breaks, set to MODE 2.
 Sound break may occur depending on your Bluetooth receiving device when
switching between MODE 1 and 2.
1
GB