Connecting The Controller - Waeco PerfectView VS 400 Montage- Und Bedienungsanleitung

Connecting electrical power to the video splitter
7.2
➤ Connect this connection (fig. 6 1, page 5) to the controller.
➤ Connect this connection (fig. 6 2, page 5) to the monitor.
➤ Connect the cable set (fig. 5 3, page 4) to the plug of this connection
(fig. 6 3, page 5).
7.3
The cable set features the following connections:
fig. 0, page 6
➤ Connect the camera connections (fig. 0 1, page 6) to the cameras.
➤ Connect the red cable (fig. 0 2, page 6) to the positive wire (+) of the
vehicle.
➤ Connect the black cable (fig. 0 3, page 6) to the earth wire (–) or to earth
(bodywork).
➤ Connect the green cable (fig. 0 4, page 6) to the positive wire (+) of the
reversing light (camera 1).
➤ Connect the white cable (fig. 0 5, page 6) to the control signal for
camera 2.
➤ Connect the blue cable (fig. 0 6, page 6) to the control signal for
camera 3.
➤ Connect the brown cable (fig. 0 7, page 6) to the control signal for
camera 4.
32
Downloaded from www.Manualslib.com

Connecting the controller

Connecting the cable set
No. in
Explanation
1 Connections for camera 1 – 4, 6-pin, protected from jets of
water
2 12 V connection +, red
3 Earth connection –, black
4 Control input for reversing light (camera 1), green
5 Control input for camera 2, white
6 Control input for camera 3, blue
7 Control input for camera 4, brown
manuals search engine
VS400
EN