Listening To The Radio - Denon DRA-295 Bedienungsanleitung

Checking the currently playing program source, etc.
B
2 1
6 7 0 1
TUNER CD CDR DVD / VDP
SHIFT TAPE AUX
2
• DIMMER A •
PRESET STATUS SPEAKER MASTER VOL
ª B ª
1
MUTING
B
REMOTE CONTROL UNIT RC-907
Recording the program source (recording the source currently being monitored)
1
Follow step 1 to 3 under "Playing the input source".
Simultaneous recording
The signals of the source selected with the function selector button are output simultaneously to the TAPE and
CDR REC OUT jacks. If a total of two tape decks are connected and set to the recording mode, the same
source can be recorded simultaneously on every decks.
NOTES:
• The AUDIO IN's signal selected with the function selector button are output to the TAPE and CDR AUDIO
OUT jacks.
Downloaded from www.Manualslib.com
1 Front panel display
• Descriptions of the unit's operations are also
displayed on the front panel display. In
addition, the display can be switched to check
the unit's operating status while playing a
source by pressing the STATUS button.
STATUS
(Main unit)
2 Using the dimmer function
• Use this to change the brightness of the
display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing the
main unit's DIMMER button repeatedly.
DIMMER
(Main unit)
The brightness changes in 3 steps each time the
button is pressed, and finally the display turns off.
2
Start recording on the tape deck or CD recorder.
For instructions, refer to the component's operating
instructions.
manuals search engine

9 LISTENING TO THE RADIO

Auto preset memory
This unit is equipped with a function for automatically searching for FM broadcast stations and storing them in the
preset memory.
STATUS
B
(Remote control unit)
1, 2 3 1
DIMMER
(Remote control unit)
2 DEFAULT VALUE
AUTO TUNER PRESETS
A1 ~ A8
B1 ~ B8
C1 ~ C8
D1 ~ D8
E1 ~ E8
1
When the main unit's power operation switch
turn on while pressing the set's MEMORY button
the unit automatically begins searching for FM
broadcast stations.
(Main unit)
2
When the first FM broadcast station is found, that
station is stored in the preset memory at channel
A1. Subsequent stations are automatically stored
in order at preset channels A2 to A8, B1 to B8, C1
to C8, D1 to D8 and E1 to E8, for a maximum of
40 stations.
3
Channel A1 is tuned in after the auto preset
memory operation is completed.
NOTES:
• If an FM station cannot be preset automatically
due to poor reception, use the "Manual tuning"
operation to tune in the station, then preset it
using the manual "Preset memory" operation.
• To interrupt this function, press the power
operation switch.
87.5/89.1/98.1/108/90.1/90.1/90.1/90.1 MHz
522/603/999/1404/1611 kHz/90.1/90.1/90.1 MHz
90.1 MHz
90.1 MHz
90.1 MHz
ENGLISH
AUTO PRESET
9