GEZE Slimdrive SD Zusatz-Montageanleitung Seite 11

Integrierte Schließfolgeregelung Bandseite Slimdrive SD Mat. Nr. 83221, Datei 83221 SD_IS-BS_141199.p65
Installation "1st closing leaf DIN left"
Installing Slimdrive SD-IS on the side of the 1st closing leaf
SD-IS: identifiable by the valve lever next to the spindle drive. Valve
lever (and rope) at the bottom.
Installing Slimdrive SD or TS 5000 on 2
The U-shaped driver has to be mounted on this side of the drive:
Important: Thoroughly grease all parts before mounting!
Put driving plate on top and with nose pointing to screwing surface
in accordance with illustration.
Slip U-shaped accessory part (all sliding surfaces thoroughly
greased!) from the rear onto the screwing surface of the drive.
TS 5000 only:
Take note of the shims as distance piece for the driver to be
mounted.
Installation "1
Installing Slimdrive SD-IS on the side of the 1
SD-IS: identifiable by the auxiliary valve lever next to the spindle drive (see illustration above, respectively). Valve lever
and rope on the top.
Installing Slimdrive SD or TS 5000 on 2
The U-shaped driver has to be mounted on this side of the drive:
Driver on the rear side (= screwing surface),
observe mark as described above
Representation: TS 5000
nd
Driver on the rear side (= screwing surface),
nose 90° towards mark on the hexagon head,
rear side
st
closing leaf DIN right"
st
closing leaf
nd closing leaf side
Valve lever of SD-IS
closing leaf side
Representation: TS 5000
11