Setting Up And Aligning The Appliance; Cleaning Before Use; Commissioning The Appliance - hanseatic HKGK16155EW Gebrauchsanleitung

Page EN-24 Start-up
– If underfloor heating is installed at the set-
up location, place the cooling appliance on
an insulation plate made from solid mate-
rial.
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using the two front screw feet (4).
4. Close the doors.
5. Tilt the appliance backwards slightly and
screw/unscrew the screw feet.
6. Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the doors.

Cleaning before use

In order to remove the odour which is pres-
ent in all new appliances, wipe the fridge and
freezer compartment out prior to first use
with a solution made from 100 ml vinegar
and 200 ml water. Then wipe it out with clean
water and dry all of the parts off afterwards.

Commissioning the appliance

CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re and property damage.
Only connect the appliance to a
■
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
(4)
pressor may get into the cooling circuit.
Allow the appliance to stand upright
■
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
When opening and closing the fridge com-
partment door, the interior light (2) is auto-
matically switched on and off.
You will find all important information
about operation starting on page EN-12.