Installation; Installing/Replacing The Lamp; Danger To Life - EuroLite DE-1 Bedienungsanleitung

Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
Attention: The operation of warning beacons in Germany is permitted only in non-public areas.
Use in public traffic (streets, roads, and plazas) is prohibited!
This prohibition applies also to areas immediately adjoining public traffic, since an endagering of

INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one 230 V/18 W E-14 lamp.During operation, the lamp reaches temperatures
of up to 285° C.
Procedure:
Step 1: Unscrew the screws of the clamps.
Step 2: Remove the color cap.
Step 3: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 4: Put the new 230 V/18 W E-14 lamp into the lampholder.
Step 5: Replace the color cap and tighten the screws.
the traffic flow cannot be excluded!

DANGER TO LIFE!

Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened color cap!
13/16 00064078.DOC, Version 1.4