Page EN-24
Dishwasher operation
Starting the dishwashing
programme
(6)
1. Start the programme with the
ton (11). If you
– have not set up a start delay, the pro-
gramme cycle will begin after a few sec-
onds.
– have set up a delayed start, the display
will initially still show the start-delay du-
ration (6); the dots between the number
of hours and minutes will flash. After the
start delay runs out, the programme will
start.
During the programme the display will
show the time remaining (6); the dots be-
tween hour and minute numbers will flash.
At the end of the programme cycle, an
acoustic signal will sound 8 times and the
display will show
end
.
2. Switch the dishwasher off using the
button (18).
3. Turn the tap off.
4. Wait a little while before unloading the
dishwasher.
Unloading the dishwasher
CAUTION!
Risk of scalding!
If you open the appliance door, hot
steam will come out.
Maintain a suffi cient distance from
■
the appliance door and do not hold
your head or upper body directly
above the open appliance door.
Make sure that children do not open
■
the appliance door if the programme
has only fi nished a short time ago.
Only open the appliance door slight-
■
ly to allow the steam to escape more
easily.
Allow the dishes to cool before un-
■
loading the dishwasher.
(11)
Tripping hazard!
but-
An open appliance door can easily be-
come a trip hazard.
Close the appliance door after every
■
use.
Only leave the appliance door slightly
■
open to cool down.
NOTICE
Risk of damage!
Make sure that children and pets do
■
not stand on the open appliance door.
Once the programme has come to an end
and the dishes have cooled, you can remove
them.
1. When unloading the dishwasher, start
with the lower rack and then unload the
upper rack. This will prevent water drip-
ping onto the lower layer of dishes from
the top layer of dishes.
2. Leave the appliance door open slightly so
that the inside can cool off and dry.
If no further settings are made, the appliance
will automatically switch off after 15 minutes.