Proper Using; Compacting - Zipper Maschinen ZI-RAM80C Betriebsanleitung

Proper using

Keep the tamper clean and dry.
Prevent blank hits.
When pushing away the material or when lifting the tamper, let this in no case run with full throttle.
For optimal control guide bracket as shown.
If the tamper tilts on its side, then lie down as shown and immediately stop the engine (main switch
(3) to "OFF")
To prevent engine damage the tamper should not continue run if he is on the side.

Compacting

 Open throttle lever (A) for max. power
 Grip the guide bracket with both hands and lead the tamper. Releases in no case the guide bracken
when you are compacting.
 Let the tamper move forward itself. Do not apply pressure to the tamper. NEVER try to move the
machine with muscle power forward.
 The tamping foot must always occur in a parallel position to the ground (d) to avoid extreme wear
on the drive.
 A ground with too much moisture can reduce a good compression. Let dry the ground before
compaction something.
 A very dry ground swirls when working with the tamper much dust. By adding moisture the
compression can be improved and the maintenance of the air filter can be reduced.
The tamper does not apply to concrete or hard or compacted surfaces. In such
cases the device will jump rather than vibrate causing damage to the tamping foot
and motor.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RAM80C
NOTE
NOTE
OPERATION
30