BRAYER BR4902 Benutzerhandbuch Seite 9

- remove the battery if you are not planning to use
the unit for a long time;
- remove the used battery from the remote control
(25) and dispose of it.
Preparing the filters before the using the air purifier
• Remove the lid (1) (pic. 3).
• Remove the filters from the air purifier»s body.
• Unpack the filters (pic. 4).
• Install the HEPA filter (10) into the air purifier body
(pic. 5).
• Install the second two-piece (catalytic + coal filter),
make sure that the »puller» is pointing towards you
(pic. 5).
• Install the prefilter (8) (fig. 5).
• Install the front lid (1) back to its place (pic. 6).
• The air purifier is ready for operation.
USING THE AIR PURIFIER
• Place and use the air purifier on a flat dry and steady
surface. The distance between the unit body and
other furniture and interior objects should be at least
20 cm and 30-50 cm above the unit.
Switching on
• Insert the power plug into the mains socket and a
beep will sound on the control / indication panel
(2) for the self-test, all symbols will be displayed
alternately, and then all symbols will flash and go out
- the air purifier is in standby mode.
• Every pressing of the active button is accompanied
by a sound signal.
• To turn on the air purifier, press the «On / Off» button
(11) on the control / indication panel (2) or press the
«On / Off» button (20) on the remote control (25) and
the air purifier will start up.
• Numerical symbols (18) will show the air condition in
the room:
- less than 19 (polluted air);
- 20-29 (normal air composition);
- more than 30 (clean air).
• To turn off the air purifier, press and hold the «On /
Off» button (11) on the control / indication panel (2)
for 3 seconds or press and hold the «On / Off» button
(20) for 3 seconds on the remote control (25) and
disconnect the power plug from the mains socket.
Speed operation mode selection
• To select a high-speed operating mode, press the
«Speed» button (12) on the control / indication panel
(2) or press the «Speed» button (22) on the remote
control (25) and the operating mode indicators (15)
will light up:
- « » maximum speed
- « » medium speed;
- « » low speed (night mode)
- « » automatic operation mode, high-
speed operation mode of the air purifier is set
automatically depending on the air purity in the
room.
EN 9