Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

18.3

Control Panel

Description
START Key:
start a spin cycle. Note: Lower the
1
protection hood to activate a spin cycle
NOTICE:
spin cycle.
STOP Key:
the following functions in each status:
· Stop spin cycle in emergency when the
2
wheel is spinning
· Activate the wheel lock (solenoid
brake) when the wheel is not spinning,
deactivate it by pressing STOP key again.
HIDE Key:
hidden weight function (behind the
3
spokes) when ALU-S program is
activated.
SPL Key:
4
Locator key to locate the wheel to the
balancing weight position.
Fn / Static Key:
5
between dynamic and static balancing
modes.
<T Key:
6
imbalance weight amount reading below 5
grams o r ¼ ounce.
C Key: Press this key to perform the
Following functions in each status:
· Recalculate the balancing result after a test
spin done, after changing either of A, W and D
7
data, press C key to do recalculation without
additional spin;
· Exit program during in process of some
Programs.
ALU Key: Press this key to ALU-S balancing
8
program.
election of functions 1 → 2 → 3 → 4 → 5
ZIPPER MASCHINEN GmbH
ZI-RWM84
Press the START key to
Lower the hood to activate a
Press STOP key to perform
Press this key to enter the
Press the Smart Position
Press this key to toggle
Press this key to indicate actual
www.Zipper-Maschinen.at
Description
USER Key:
to swich to the desired user. Press
9
Fn+ USER key to save presetting
data in each user environment.
Vehicle Selection (MODE) Key:
10
Press this key to select the vehicle
wheel type.
"A+" Key:
11
value of rim distance A.
"A-" Key
12
down value of rim distance A.
"W+" Key:
13
up value of rim width W.
"W-" Key: Press this key to trim
14
down value of rim width W.
"D+" Key: Press this key to raise up
15
value of rim diameter D.
"D-" Key: Press this key to trim
16
down value of rim diameter D.
OPERATION
Repeat pressing this key
Press this key to raise up
: Press this key to trim
Press this key to raise
38

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis