Install The Batteries - Hitachi RAR-5J1 Anleitung

PREPARE THE REMOTE CONTROLLER

Install the batteries.

1
Use two AAA-size batteries.
1. Do not mix new and old batteries, or
different type of batteries together.
2. Remove the batteries when you do
not use the remote controller for 2 or 3
months.
3
Set the current time (Ex: set to 13:30 )
ABOUT ADDRESS SELECTOR SWITCH
Address selector switch is used to prevent
remote controller signal interference in such
circumstance where 2 indoor units are used in
the same room. This switch is not usually used.
(The factory setting is at "A" side.)
For this setting, please make an inquiry to your
sales agent.
Downloaded from www.Manualslib.com
Push
and pull.
CAUTION
1
2
Confirm the current time
manuals search engine
Open the cover and press the RESET
2
button with a sharp tip item.
mark
Press the (TIMER) button to adjust to the current time.
You can fast forward the time by continuously pressing the
button.
Time is incremented
Time is decremented
Press (CLOCK) button to set the current time.
is lit instead of
blinking. It automatically goes
off in 10 seconds.
Press the (CLOCK) button to check the current time
(The time display disappears 3 minutes later). If necessary,
readjust the time following the above procedure 1 and 2 .
Address
Remote controller
backside
– 4 –
RESET
18:88 lights up on the current
time display and start
blinking.
Address
Address selector
switch
Switch lever
Do not operate by yourself.