Electrolux TWSL4IE301 Benutzerinformation Seite 26

26 www.electrolux.com
12.2 Troubleshooting
Problem
The tumble dry‐
er does not op‐
erate.
Unsatisfactory
drying result.
The loading
door does not
close
It is not possi‐
ble to change
the programme
or option.
It is not possi‐
ble to select an
option. An
acoustic signal
is emitted.
Possible cause
The tumble dryer is not connec‐
ted to the mains supply.
The door is open.
The On/Off (Ein/Aus) button
was not pushed.
The Start/Pause button was
not touched.
The appliance is in standby
mode.
Incorrect programme selection.
The filter is clogged.
Dryness (Trockengrad) op‐
iron dry (Bü‐
tion was set to
3)
geltrocken) .
The load was too large.
The airflow slots are clogged.
There is some dirt on the humidi‐
ty sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
tion.
Laundry is trapped between the
door and the seal.
After a cycle starts it is not possi‐
ble to change the programme or
option.
The option you tried to select is
not available for the selected
programme.
Remedy
Connect it to the mains socket.
Check the fuse in the fuse box
(domestic installation).
Close the door.
Push the On/Off (Ein/Aus)
button.
Touch the Start/Pause but‐
ton.
Push the On/Off (Ein/Aus)
button.
Select a suitable programme.
2)
Clean the filter.
Change Dryness (Trocken‐
grad) option to a higher level.
Do not exceed the maximum
load size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi‐
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
1)
4)
2)