Electrolux TWGL3E301 Benutzerinformation Seite 23

Problem
Incorrect programme selection.
The filter is clogged.
tion was set to
geltrocken) .
The load was too large.
Unsatisfactory
drying result.
The airflow slots are clogged.
There is some dirt on the humidi‐
ty sensor in the drum.
The dryness level was not set to
the desired level.
The condenser is clogged.
The filter is not locked into posi‐
The loading
tion.
door does not
Laundry is trapped between the
close
door and the seal.
It is not possi‐ After a cycle starts it is not possi‐
ble to change ble to change the programme or
the programme option.
or option.
It is not possi‐ The option you tried to select is
ble to select an not available for the selected
option. An programme.
acoustic signal
is emitted.
There is no Defective drum lamp.
drum light
Unexpected The drying duration is calculated
duration time according to load size and
appears on the dampness.
display.
The water container is full.
A programme
is inactive.
Possible cause
Dryness (Trockengrad) op‐
iron dry (Bü‐
3)
Remedy
Select a suitable programme.
2)
Clean the filter.
Change Dryness (Trocken‐
grad) option to a higher level.
Do not exceed the maximum
load size.
Clean the airflow slots at the bot‐
tom of the appliance.
Clean the front surface of the
drum.
Adjust the dryness level.
Clean the condenser.
Put the filter in the correct posi‐
tion.
Remove trapped items and close
the door.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
Turn the tumble dryer off and on.
Change the programme or op‐
tion as required.
Contact the service centre to re‐
place the drum lamp.
This is automated - the appli‐
ance is working correctly.
Drain the water container, push
the Start/Pause button.
ENGLISH 23
1)
4)
2)
2)