Hamilton Beach Commercial Tango-Serie Bedienungsanleitung Seite 6

A-1G91300 ENv01 11/7/01 2:31 PM Page 6
Operation
Professional Blending Techniques
Filling the container
When filling the container with ingredients, follow
these recommendations:
• Use sufficient amount of liquid to ensure that
the mixture is fluid and free-running at all
times. Pour the liquid into the container FIRST.
• Cut solid ingredients into pieces that are no
bigger than a 25mm (1") cube.
• Add the ingredients to container in batches.
Do not blend maximum volume all at once.
• Do NOT overfill the container with product.
This may prevent the blender from processing
the product properly. Process dense foods or
thick mixtures in small batches, and remember
that the volume of the product normally
increases during processing.
• Do not exceed 240 ml (8 oz.) of content when
blending hot product.
• Always place the cover and filler cap on the
container when blending. For blending hot
liquids, remove filler cap from container cover
before blending.
Blending techniques
Icy drinks – Do not use blender to crush large
ice cubes. The blender is not designed for this.
Small ice cubes or crushed ice is recommended.
Pour in liquid, then add ice. Cover. Turn blender
On and process until desired consistency is
reached. Chunks of frozen fruit can be added to
milk or fruit juice to produce a sherbet or slush.
6
wWARNING
Burn Hazard
Always use caution when blending
hot contents.
Failure to follow these instructions
can result in burns.
Blending hot mixtures
IMPORTANT: To minimize the possibility of
scalding, the following precautions MUST
be observed:
• Do not exceed 240 ml (8 oz.) of content when
blending hot product. Remember that the
volume of the product normally increases
during processing.
• Always place the cover on the container and
remove the filler cap from container cover
when blending hot liquids to prevent the build
up of pressure.
• Never stand with your face directly over the
container when operating the blender where
steam may be released.
1. Begin on Low speed and then select High
speed to produce a column of air in the center
of the container.
2. After blend stabilizes/finishes pulsing, remove
the cover from the jar to allow steam to
escape.
Filler Cap
Use the filler cap to add liquids to the container
while the unit is running.
Operation