Mounting The Camera On The Windscreen; Providing Electric Power - Kompernass CR 5 A1 Bedienungsanleitung

Mounting the camera on the windscreen

1) To increase the protection for the camera,
2) Screw the cradle
3) Place the suction cup fi rmly against the wind-
4) After attaching the camera with the suction
5) Once you have found the desired position and orientation, retighten the knurled

Providing electric power

1) Connect the car adapter
2) Connect the supplied USB cable
CR 5 A1
Downloaded from www.Manualslib.com
you can place the camera in the protective
housing and push it gently into place until
the camera clicks into place.
into the thread of the
camera Position the suction cup on the wind-
screen. Ensure that the suction cup is pressed
on fl at.
screen and press the suction cup locking
lever downwards towards the windscreen.
This creates suction, and the suction cup is
pulled tightly against the windscreen. Pull the
locking lever in the opposite direction to
release the suction cup from the windscreen.
cup on the windscreen, loosen screws A–C
and adjust the camera as per your wishes.
screws .
CAUTION
► The camera must be positioned so that the driver's fi eld of vision is not
obscured.
CAUTION
► Use only the supplied car adapter to power your device.
lighter). The operating light
readiness when the socket is live.
and the USB socket of the camera. As soon as the camera is powered by the
on-board power supply, the video recording starts and the operating display
fl ashes alternately red and green. Once the internal backup battery is charging,
the battery charger symbol
manuals search engine
to your vehicle's on-board power supply (cigarette
on the car adapter
to the USB port
appears on the screen
indicates operational
on the car adapter
.
GB
IE
9