Operating The Appliance; Setting The Timer; Connecting The Power Supply; Setting The Temperature - Silvercrest SKMH 1100 A1 Bedienungsanleitung

Downloaded from www.Manualslib.com
RP93471 Küchenmaschine mit Heizung LB5 Seite 85 Donnerstag, 14. August 2014 3:36 15
For safety reasons, the settings described in
this section may only be selected when the
appliance has been fully assembled (see
"7. Using the blender jug" on page 87 or
"8. Steaming" on page 92).

6.1 Connecting the power supply

1. Insert the power supply plug into a
suitable mains socket (see "3. Technical
data" on page 80):
– the operating indicator 7 will light up
red;
– the display 8 will light up and show all
the control symbols. All the adjustable
values are set to "0".
– An audible signal sounds.
6.2 Displays
All the settings and operating values are
shown on the display 8.
The display 8 illumination will go out after a
certain time. As soon as you press one of the
buttons or turn one of the controls the
display 8 will light up again.
The operating indicator 7 shows the current
state of the appliance:
– red: Appliance is connected to the
power supply but is not in operation
– blue: Appliance is in operation
SKMH 1100 A1
manuals search engine

6. Operating the appliance

6.3 Setting the timer

You can use the "TIME" controller 10 to set
how long cooking or processing is to take:
Timer "-"10: reducing the time
Timer "+" 10: increasing the time
• You can set up times between 1 second
and 60 minutes.
• The currently set time is shown on the
display 8
• when the function is started the time
begins counting down;
• the time can be modified while the
appliance is in operation;
• Once the set time has elapsed:
– the appliance stops;
– an alarm is heard.

6.4 Setting the temperature

You set the cooking temperature by turning
the "TEMP" temperature controller 13:
• You can set up temperatures between
37 °C and 100 °C;
• The currently set temperature is shown
on the display 8
• As soon as the selected
temperature is reached,
the appliance emits an
audible
displays an appropriate
symbol;
signal and
85