Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
the upper limit depends on the load value and is calculated as the cur-
rent at start plus 15%.
11.2.7 Emergency Off
The welding process has been interrupted by pressing the STOP/RESET
key.
11.2.8 Heater Coil Error
The current value during welding differs by more than 15% from the
nominal value, indicating a short-circuit in the heater coil.
11.2.10 Power Supply Failure
The last welding is incomplete. The welding device was disconnected
from power supply voltage.
12
HST300 Pricon+ Technical Specifications
Nominal Voltage
Frequency
Power
Protection Index
Primary Current
Ambient Temperature
Output Voltage
Max. Output Current
Memory for Reporting Protocols
Tolerances:
Temperature
Voltage
Current
Resistance
USB A Interface (at the front of the unit)
for connecting USB printers and USB mass storage media (such as
a USB stick)
USB B Interface (at the back of the unit)
for connecting the welding unit directly to a PC
Both interfaces comply with the USB version 1.1 specification (i.e., maxi-
mum data rate of 12 megabits per second).
Important
13
Service and Repair Contact
Hürner Schweisstechnik
Nieder-Ohmener Str.
35325 Mücke, Germany
Web: www.huerner.de
Info
20
EN
Downloaded from
www.Manualslib.com
To work properly, the used printer has to support PCL (Printer
Command Language). Please refer to the manual of your
printer for more information. A list of supported printer makes
is also available from Hürner Schweisstechnik on-line at
www.huerner.de
We reserve the right to change technical specs of the unit
without prior notice.
manuals search engine
230 V
50 Hz - 60 Hz
2800 VA, 80 % ED
IP 54
16 A
- 20 °C to + 60 °C
8 V - 48 V
110 A
2000 reports
± 5 %
± 2 %
± 2 %
± 5 %
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HST300 Pricon+ User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
Version January 2009
Werbung
Kapitel
Inhaltsverzeichnis
