Adjusting The Output Level; Interference Suppression; Key Lock - Monacor JTS UF-10R/12 Bedienungsanleitung

6.3 Adjusting the output level

1) To perfectly match the output level to the unit
connected, call up the menu item
the main menu.
Setup Volume
-10dB
2) Turn the knob PUSH / CONTROL to adjust the
output level (-31 dB ... 0 dB). To mute the
sound, turn the knob counterclockwise until the
Mute
message
-31 dB.
3) Press the button SETUP to save the setting.
4) After the main menu has been exited, the value
adjusted is indicated on the display next to the
Mute
symbol :
indicated together with

6.4 Interference suppression

The interference suppression will mute the receiver
in speech / music pauses when interfering signals
are received and the levels of these signals are
below an adjustable threshold value. A high thresh-
old value, however, will also reduce the transmis-
sion range as the receiver will also be muted if the
power of the radio signal falls below the threshold
value adjusted. Therefore, adjust a high threshold
value when the reception is good and a low value
when there is a great distance between the trans-
mitter and the receiver.
1) Call up the setting for interference suppression
via the menu item
Setup Squelch
2) Turn the knob PUSH / CONTROL to set the
threshold value:
0 = standard setting
1 .... +10 in case of good reception
-1 ... -5 in case of great distance
3) Press the button SETUP to save the setting.
18
All manuals and user guides at all-guides.com
Volume
Fig. 20
appears following the value
-31 -1
, ... ; the setting 0 dB is
Max.
Squelch of the main menu.
0
Fig. 21

6.5 Key lock

The receiver is provided with a key lock to prevent
of inadvertent switch-off or operation.
Activating the lock
1) Call up the lock function via the menu item
Lock
of the main menu.
Setup Key Lock
Lock ON
Lock OFF
2) Turn the knob PUSH / CONTROL to select the
setting Lock ON
3) Press the button SETUP to save the setting.
The menu disappears and the key symbol
the top left corner of the display indicates that
the lock has been activated.
When you press a button, the following message
appears:
Press Set for 2 Sec. to unlock keyPad
Deactivating the lock
1) Keep the button SETUP pressed for two sec-
onds until the menu
pears.
2) Turn the knob PUSH / CONTROL to select the
Lock OFF
setting
3) Press the button SETUP to save the setting.
Fig. 22
.
Setup Key Lock
.
Key
in
ap -