Teka HPS-735 Bedienungsanleitung Seite 28

3172755-000 EPIFA 26/05/14 09:30 Página 28
My accessories and shelf
supports are damaged.
The enamel colour has
changed and stains have
appeared.
The oven door is locked, pilot
light is lit up but the oven
is not hot.
I have turned the control dial to
position
pyrolisis programme (P1, P2 or
P3) but the pilot light
not lit up and the oven is not
heating up.
I have turned the control dial to
position
pyrolisis programme (P1, P2 or
P3) but the pilot light
not lit up and the oven is not
heating up.
I have programmed the
pyrolysis function, the oven is
working properly but pilot light
is not lit up.
The pyrolysis programme has
ended and the oven is cold,
but the door is locked and
symbol
28
Downloaded from www.Manualslib.com
INCIDENTS WHEN OPERATING THE PYROLYTIC FUNCTION
INCIDENT
You have not removed the
accessories and supports during
the pyrolytic cleaning cycle.
The chemical composition of
some foodstuffs may cause
changes in the enamel.
You have turned the control
dial to position
other additional operation has
been performed.
The oven door is not closed
and selected a properly, so the door cannot
be locked.
has
The door switch is not working
and selected a even though the door is
properly closed.
has
Pilot light
properly.
You did not turn the control
dial to position
pyrolysis programme ended.
is flashing.
manuals search engine
CAUSE
You must replace them and
remove them in later cleaning
cycles.
This is normal and does not
damage the properties of the
enamel.
Switch off the oven and follow
and no the instructions to unlock the
door in the first 30 minutes at
a low temperature.
Next, select the pyrolytic
function, carefully following the
instructions.
Check the door and make
sure that it is closed properly.
Call Technical Assistance
Service as there is a fault in
the door switch.
Call the Technical Assistance
does not work
Service.
1. Turn the control dial to
position
when the
minute.
2. Turn the control dial to
position
minute.
3. Turn the control dial to
position
until pilot light
SOLUTION
and wait for 1
and wait for 1
again and wait
turns off.