Projection Unit; Motion Sensor (Msr939); Setup Sensor - Oregon Scientific RMR939P Bedienungsanleitung

2. Use the or
soothing sound.
3. Press the SOUND / SLEEP button to confirm the
setting.

PROJECTION UNIT

The projection unit can display both time and alarm
status. To use this feature:
• Slide the PROJECTION switch to ON to activate
continuous projection. However, this function will
not work unless the AC / DC adaptor is used.
• Adjust the FOCUS knob to make the image
clearer.
• Adjust the IMAGE ROTATION knob to rotate the
image clockwise or anti-clockwise.
• Manually tilt the projection unit to position the
image or press the 180° ROTATION button to
reverse the image and turn it upside down.
RMR939P English R8 OP
Downloaded from www.Manualslib.com
buttons to change the type of
18
Black
manuals search engine
NOTE You can also press the SNOOZE / LIGHT button
to project the time and alarm status for 5 seconds.

MOTION SENSOR (MSR939)

The motion sensor has a security / monitoring function.
It can set off your motion alarm on the clock for 5 minutes
and turn the backlight on for 10 seconds when it detects
movement.
Data can be collected from up to 2 sensors. Additional
sensor sold separately.

SETUP SENSOR

1. Slide the motion sensor battery door open.
2. Insert the batteries, matching the polarity (+ and -)
as shown in the battery compartment.
SWITCH OPTION
Channel Channel 1-2. If you are using more
than one sensor, select a different
channel for each sensor.
3. Set the channel by sliding the CHANNEL switch to
1 or 2. The switch is located in the battery
compartment.
4. Set the code by sliding the CODE switches to the
same setting as the Code on the clock display. This
enables the clock and motion sensor to interact with
each other.
18
8/23/04, 11:55 AM