Remote Control; Battery Installation - Sharp HT-SB350 Bedienungsanleitung

Remote control

Battery installation

1 Insert pin into the hole as shown and pull to open the
battery holder.
Back of
remote control
2 Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Battery holder
Battery type
Locking tab
Polarity (+) symbol
Precautions for battery use:
Remove the battery if the unit will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
Downloaded from www.Manualslib.com
Pin
Positive (+) side up
manuals search engine
Caution:
Do not use rechargeable battery (nickel-cadmium battery, etc.).
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Installing the battery incorrectly may cause the unit to
malfunction.
Notes concerning use:
Replace the battery if the operating distance is reduced or if
the operation becomes erratic. Purchase "CR 2025", coin
lithium battery.
Periodically clean the transmitter on the remote control and
the sensor on the unit with a soft cloth.
Exposing the sensor on the unit to strong light may interfere
with operation. Change the lighting or the direction of the unit
if this occurs.
Keep the remote control away from moisture, heat, shock,
and vibrations.
Test of the remote control
Point the remote control directly at the remote sensor on the unit.
The remote control can be used within the range shown
below:
Press the ON/STAND-BY button. Does the power turn on? Now,
you can enjoy your system.
Remote sensor
2010 August 16
0.2 m - 6 m
(8" - 20')
15° 15°
HT-SB350_A6_EN_UK.fm
HT-SB350(W)
HT-SB350(BK)
ENGLISH
E-14