Using Your Steam Mop - Lakeland 23307 Bedienungsanleitung

Using your steam mop

1. Sweep or vacuum your floors before using your steam mop.
2. Pull and twist the quick release cord holder to unwrap the power cord completely.
Plug in and the "On" light will turn green. If your light doesn't turn on, turn to the
Troubleshooting section, page 6.
3. To adjust the height of the mop lift the latch on the tube 90 degrees to the open position.
Holding the handle, extend the tube to the height that's right for you and then close the
latch to its locked position.
4. It takes about 30 seconds for the steam to be ready for use. Pump the handle a few times
to prime the pump and activate steam.
5. Mop with a forward and backward motion to customize steam output automatically. If
you find the steam mop difficult to push/pull during use, then simply increase the height
of the pole.
Microfibre pads
Washing instructions:-
• Machine washable up to 40°C
• Use liquid detergent only
• Do not bleach or use fabric conditioner
• Wash separately from other fabrics
• Air dry or tumble dry on low setting
If there are loose threads on the pad carefully cut the thread with scissors. Do not pull on
them or cut at the base.
To order replacement pads, call the Helpline on 015394 88100.
3 Replacement Microfibre Pads ref: 23308
6
Downloaded from www.Manualslib.com manuals search engine