Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Blink codes
Initial startup
Battery charging
1. Charge the battery.
Illustration B
Note
The charge indicator flashes during the charging procedure.
It lights up continuously for 1 hour when the battery is fully
charged. For information on the charging time, see Chapter
Technical data.
Operation
General information on handling the device
Clean the device each time before use (see Chapter
Cleaning the device).
Regularly clear the car windows of dirt to remove dirt par-
ticles that could cause scratches. Notice that the greatest
14
● LED lights up permanently:
The device is in operation.
● LED lights up for 1 h: The
device is connected to the
power supply and the battery
is fully charged.
● During operation: Low
battery voltage warning.
● The battery is discharged.
● During charging: Battery is
being charged.
A fault has occurred (see Chap-
ter Troubleshooting guide).
contamination is outside the wiping area of the wind-
screen wipers. That is why it is not enough to clean the car
windows with the windscreen washer system alone.
Illustration C
When scraping ice on an uncleaned windshield, limit it to
the wiping area of the windscreen washer system in order
to avoid possible scratches due to dirt from the edge are-
as.
Guide the device slowly over the surface while pressing
lightly.
At regions with thicker ice, leave the device at the same
position until the ice breaks.
Note
Extra de-icing agents are not required.
Starting up the device
1. Press the power switch.
Illustration D
The device is switched on and is in standby mode.
2. Pull off the protective cap by pressing at the side.
Illustration E
3. Position the device on the windscreen. Take care to en-
sure adequate clearance to seals and paintwork.
Illustration F
4. Actuate the trigger switch.
Illustration G
The scraper disc starts rotating.
ATTENTION
Improper storage
Damage to the device and battery
Do not store the device in a vehicle for longer periods of time.
English
Storage
Werbung
Kapitel
Fehlerbehebung
