Beper BT.001N Handbuch Seite 9

EN
Toaster Use instructions
Description Fig.A
1. Pliers
2. Slots
3. 6 levels toasting knob
4. Removable crumb tray
5. Switch lever
6. Stop/Cancel button
7. Defrost button
8. Reheat button
Use
Remove all packaging and clean the appliance carefully.
Place the appliance on a stable and flat surface.
Insert pieces of bread in the pliers than insert the pliers into appropriate slots.
Plug the cord supply into the socket.
Turn the knob to select the toasting level desired between 6 levels.
Put down the switch lever and the toaster start working, it will stop automatically when the time/level is over,
pliers will rise automatically from the slots.
If bread is not enough toasted, select higher toasting level, or if it is too much toasted, select lower one. The
toasting can be stopped at any time by pressing the stop/cancel button; the pliers will automatically rise from
the slots.
Take care while touching the bread as it will be very hot.
The toaster is equipped with 2 additional functions:
"Defrost" function
Frozen slices of bread may be toasted by pressing the defrost button immediately after lowering the lever; the
toasting cycle will be lengthened in order to achieve the desired browning. The defrost indicator light will remain
lit while the defrost function is in use.
"Reheat" function
To warm toast that has popped up but gone cold, lower the lever again and then press the 'Reheat' button.
Please note that this is fixed reheat time which cannot be adjusted by the browning control. The reheat function
can be cancelled at any time by pressing the Stop/Cancel button . The reheat indicator light will remain lit while
the reheat function is in use.
For better toasting
When used for the first time, do not put bread into the toaster; that will allow to the heat resistance to pre-heat
and to eliminate the typical smell of new item.
To get better results, use same thickness, size and freshness piece of bread. Do not put food that could make
juice or other, in order to prevent from damages or fire and make it hard to clean.
The sliding crumb tray must always be cleaned after each use.
To get homogeneous toasting, it is recommended to wait at least 30 seconds before toasting again.
Cleaning and care of the toaster
Always unplug the cord supply from the socket before cleaning or care. Let the toaster to cool down. The external
part of the toaster can be cleaned with a smooth cloth. Do not use alcohol, abrasive detergents or every deter-
gent that could damage the toaster.
Do not immerse into water.
If there remain embedded pieces of bread, unplug the cord supply from the socket, turn over and slightly shake
the toaster. Do never touch the parts of the toaster with cutting utensils, especially inside the slots.
After use, unplug the cord supply from the socket and let the toaster to cool down before store it.
After each use open the removable crumb tray, empty it and clean with a soft dampened cloth.
Technical data
Power: 750W
Power supply : 220-240v ~ 50/60Hz
For any improvement reasons, beper reserves the right to modify or improve the product without any
notice
9