Operation; Requirements For Safe Use; Switching The Appliance On And Off .En; Setting The Temperature - hanseatic HGS18560ENFW Gebrauchsanleitung

Operation

Requirements for safe use

– You have read chapter "Safety" from page
EN-5 and understand all the safety notices.
– The appliance is set up and plugged in as
described in chapter "Start-up" from page
EN-19.
Switching the appliance on
and off
(1) (2)
(6)
Switching on
1. Press and hold down the on/off button (6)
for approximately 3 seconds.
The interior light (19) will light up and the
temperature display (2) will appear. The
appliance is switched on.
The compressor starts to work, the refrig-
erant flows through the pipes and a quiet
humming sound can be heard.
2. If the appliance is making unusual noises,
check that it is stable and remove any ob-
jects that may be on top of it.
Switching off
1. Press and hold down the on/off button (6)
for approximately 3 seconds.
The interior light (19) will light up and the
temperature display (2) will disappear.
The compressor is now switched off. The
appliance doesn't refrigerate.
2. Empty the appliance and clean it (see
"Care and maintenance" on page EN-17).
3. To switch off the appliance entirely, dis-
connect the mains plug from the socket or
switch off / unscrew the fuse.
4. Leave the door open slightly to avoid
mould formation.

Setting the temperature

Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
(3) (4)
Using the buttons 'Increase temperature' (4)
and 'Decrease temperature' (5), you can set
the temperature in the appliance. The tem-
perature display (2) shows the set temper-
ature.
(5)
You can set the freezer to a temperature be-
tween −16 °C and −24 °C. The optimal freez-
er temperature is −18 °C. The freezer has
been preset to this temperature.
• First select a medium setting.
• If, for example in summer, the ambient
To set
– the temperature higher, press the 'Increase
– the temperature lower, press the 'Decrease
The setting takes effect automatically after
3 seconds.
You ideally need a freezer thermometer to be
able to control the cooling efficiency.
• Place the freezer thermometer in one of
Operation
WARNING
Always ensure the prescribed ambi-
ent temperature is maintained (see
"Intended use" on page EN-5).
temperature increases, so select a lower
setting accordingly.
If you set a lower temperature, you
will need higher cooling perfor-
mance. This increases the energy con-
sumption.
temperature' button (4) until the desired
temperature is displayed.
temperature' button (5) until the desired
temperature is displayed.
the large freezer drawers (13); the ideal
storage temperature is –18 °C.
Page EN-11