Ec Declaration Of Conformity; Troubleshooting - Scheppach tku 4000 Originalanleitung

In the event of enquiries please specify the following data:
1. Motor manufacturer
2. Type of current of the motor
3. Data recorded on the machine's rating plate
4. Data recorded on the switch's rating plate
If a motor has to be returned, it must always be dispatched
with the complete driving unit and switch.
Optional equipment
Sliding table carriage
1200 mm:
Part no. 7951 0000
1500 mm:
Part no. 7951 0901
Table width extension
Part no. 7961 0901
Automatic switch-on unit
Typ ALV 2: Part no. 7910 4010
Typ ALV 10: Part no. 7910 4020

EC Declaration of Conformity

We, scheppach Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Str. 69, D-89335 Ichenhausen hereby declare that the ma-
chine named below correspondends to the relevant safety and health
requirements of the EC guide lines specified below in its design and
construction and in the version which we introduced to the market.
This declaration becomes invalid if changes are made to the machine
without our consent.
Failure
Saw blade gets loose after turning off
the motor
Motor does not start
Motor runs forward or backwards
Engine is giving full power,Saw blade is
running to slow
No motor output, turns off automati-
cally
Burns on the cutting surface
c) with longitudinal cuts
d) with cross cuts
16
Sliding table carriage
1300 mm:
Part no. 5278 0701

Troubleshooting

Possible cause
a) Fastening nut tightened insuffi-
ciently
a) Fastening nut tightened insuffi-
ciently
b) Extension cable defect
c) Connections on the motor or switch
defect
d) Motor or switch defect
Capacitor defect
Drive belt too slack
Overload by dull saw blade, thermopro-
tection is triggered
a) Fastening nut tightened insuffi-
ciently
c) Longitudinal stop not parallel
d) Slide carriage not parallel
Machine description:
Circular saw
Machine model:
tku 4000
Relevant EC directives:
EC machine directive 98/37/EG (< 28.12.2009), EC machine directive
2006/42/EG (> 29.12.2009), EC Low voltage directive 2006/95/EWG,
EC-EMV directive 2004/108/EWG.
Applied harmonized European Standards:
EN12100-1, EN12100-2, EN294, EN349, EN418, EN847-1, EN954-1,
EN1088, EN1870-1, EN60204-1, EN55014, EN60555-2, EN60555-3
Applied national technical standards and specifications, especially:
ISO 7960
Notified body within the meaning of Annex VII
Prüf- und Zertifizierungsstelle, Fachausschuss Holz, Vollmoellerstraße
11, 70563 Stuttgart-Vaihingen
Engaged for
(EG-Baumusterbescheinigung)
Date
Ichenhausen, 01.09.2007
Signature:
on behalf of Wolfgang Windrich (Technical manager)
Solution
a) Tighten fastening nut, M20 left-
handed thread
a) Check the mains fuse.
b) See "Electrical Connection" in the
operating manual, pages GB 16
c) Have it checked by an electrician
Brake does not bleed
d) See "Electrical Connection" in the
operating manual, pages GB 16
Have it exchanged by an electrician
Stretch drive belt
Insert a sharpened saw blade; motor
can be turned on again after the cool-
ing period
a) Insert a sharpened saw blade
c) Exchange the longitudinal stop
d) Align the slide carriage with the saw
blade