Broncolor Siros 400 Bedienungsanleitung Seite 5

> Sudden temperature differences may result in condensation forming inside the unit. In such situa-
tions allow the equipment to stand for at least one hour in a well-ventilated place to acclimatise to
the new temperature before start-up!
> Do not operate the flash equipment in places where there is an explosion hazard!
> Monolights must never be used in water, on water or submerged in any other liquid! Attention:
High voltage – danger of fatal injury!
> For safety reasons never operate the monolight without the safety glass in place! To protect eyes
from UV radiation either a UV-coated safety glass or a UV-coated flash tube must be used.
> Before start-up the monolight must be mounted on a stand or suspended from a suitable mounting.
When a lamp is suspended it must be secured to the stand adapter by tightening the retaining screw.
> For monolights, use only sand-filled fuses of the type indicated on the safety plate to protect halo-
gen lamps! Sand-filled fuses can be identified by their opaque body. If the wrong fuse is used, the
modelling lamp may burst.
> Filters or diffusers should not be fastened directly on to flash tubes, halogen modelling lamps, or
safety glasses!
> Make sure the cooling slots on the monolight are not covered or obstructed!
> When laying, clearing away or rolling up cables, make sure they do not contact hot equipment or
parts of lamps and that they do not cause a tripping hazard!
> Flash tubes, modelling lights, halogen lamps and safety glasses operate at high temperatures.
This applies also to the front face of monolights. Any accessories used on the front of a lamp also
become very hot. Take great care when handling them! Touching hot components can cause injuries!
When operating flash equipment, never touch glass or metal parts!
> After use allow the monolight to cool before packing it away!
> Monolights that have fallen over or been damaged must be checked by a competent specialist
before they are put back into service!
> To avoid danger from electric shock never open a monolight! There may still be dangerous volt-
ages inside the unit. Units should only be opened, and all service and repair carried out by author-
ised broncolor service stations. Incorrect assembly can cause dangerous contact voltages, even
on connected units.
> When using Siros in conjunction with a stand, use a sandbag if the stand is extended more than 2
metres.
> Remove the protective cover before use!
> Never put the unit in its case when it is hot!
Downloaded from www.Manualslib.com manuals search engine
7