Herunterladen Inhalt Inhalt Diese Seite drucken

Electrolux CALIMA EWM 147410 W Benutzerinformation Seite 25

Waschmaschine - trockenablage
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The door will not open:
The machine vibrates is
noisy:
Spinning starts late or the
machine does not spin:
The machine makes an un-
usual noise:
No water is visible in the
drum:
Unsatisfactory drying re-
sults:
Downloaded from
www.Manualslib.com
Problem
The programme is still running.
• Wait the end of washing cycle.
The door lock has not been released.
• Wait until the pilot light 9 goes off.
There is water in the drum.
• Select drain or spin programme to empty out the water.
The transit bolts and packing have not been removed.
• Check the correct installation of the appliance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
The electronic unbalance detection device has cut in because the
laundry is not evenly distributed in the drum. The laundry is redis-
tributed by reverse rotation of the drum. This may happen several
times before the unbalance disappears and normal spinning can re-
sume. If, after 10 minutes, the laundry is still not evenly distributed
in the drum, the machine will not spin. In this case, redistribute the
load manually and select the spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select
the spinning programme.
The machine is fitted with a type of motor which makes an unusual
noise compared with other traditional motors. This new motor en-
sures a softer start and more even distribution of the laundry in the
drum when spinning, as well as increased stability of the machine.
Machines based on modern technology operate very economically
using very little water without affecting performance.
The laundry was too wet because it had not be spun or wrung
enough.
• Do another drying cycle.
Too much items have been put on the board or they have been
put one upon another.
• Dry the items separately, spreading them out completely and
without covering one with another.
manuals search engine
Possible cause/Solution
electrolux 25

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis