Sound Bar Preparation - Sharp HT-SB602 Bedienungsanleitung

Sound bar preparation

To mount the sound bar on the wall
Caution:
z Be very careful to prevent the sound bar 3.7 kg from falling
when mounting on the wall.
z Before mounting, check the wall strength. (Do not put on
the veneer plaster or whitewashed wall. The sound bar
may fall.) If unsure, consult a qualified service technician.
z Mounting screws are not supplied. Use appropriate ones.
z Check all wall mount angle screws for looseness.
z Select a good location. If not, accidents may occur or the
sound bar may get damaged.
z SHARP is not responsible for accidents resulting
from improper installation.
„ Driving screws
SHARP designed the sound bar so you may hang them
on the wall. Use proper screws (not supplied). See below
for size and type.
3.2 mm
5 mm
Min. 22 mm
„ Fixing wall mount angle
(Horizontal position)
1
Fix the pattern paper to the wall in horizontal
position as below.
926 mm
Wall surface
44 mm
29 mm
2
Make a hole on the wall following the screw
point marks on the pattern paper by using a
drill.
8-9 mm
Wall surface
3
Fix a wall mount plug (not supplied) into the
hole using a hammer, until it is flush with the
wall surface.
32 mm
8-9 mm
Wall surface
All manuals and user guides at all-guides.com
9 mm
44 mm
29 mm
Pattern paper
32 mm
4
Screw the wall mount angle to the wall as shown
in the illustration. (Total screw is 8 pieces)
Wall mount angle
Wall mount
angle
(screws x 4)
Wall surface
(screws x 4)
Note:
Make sure all screws are fully tightened. (screws are not
supplied)
„ Installing the sound bar
1
Align the wall mount slot at the sound bar to the
wall mount angle.
2
Slot the sound bar into the wall mount angle.
3
Fix them securely.
Wall surface
E-5
Wall
Wall
mount
surface
angle
Wall surface