Conversion Of Gas Supply - Angelo Po 1N1TPGV Bedienhandbuch

Caution - Warning
Before doing any work, cut off the mains
electricity supply.
The manufacturer has tested the appliance with
its own mains gas, identifi ed by the sticker ap-
plied to the nameplate.
If the type of gas to be connected is diff erent
from that used for testing, proceed as follows.
Turn off the gas supply tap (A).
1)
Change the plate burner nozzle (see page 17).
2)
Change the plate burner pilot light nozzle
3)
(see page 18).
Change the top burner nozzles (see page
4)
17-18).
Change the oven burner nozzle (see page 16).
5)
Change the top burner pilot light nozzles
6)
(see page 18).
Change the oven burner pilot light nozzle (see
7)
page 19).
If necessary, change the oven burner bushing
8)
(see page 16).
Adjust the minimum setting on the gas con-
9)
trol valves of the hob (see page 15), oven (see
page 15) and plate (see page 14) burners.
Remove the sticker from the nameplate and
10)
apply the new one to identify the gas being
GB
used.
Important
On completion of the operation, make sure
that there are no gas leaks or malfunctions.
3320110_inst_GB_rev.1

CONVERSION OF GAS SUPPLY

- 12 -
A
ENGLISH