Control Panel - Atag VA9111RT Benutzerinformation

Optical signal
After the start of the washing programme, an
optical signal shows on the floor below the
appliance door:
• A red light for all the washing programme
duration.
• A green light when the washing pro-
gramme ends.

Control panel

1 Display
2 Delay start button
3 Programme selection buttons
4 Energy saver button
5 Multitab button
6 Half-load button
7 Indicator lights
8 On/off button
9 Function buttons
1)
It comes on when it is necessary to fill the salt container. Refer to 'Use of dishwasher
Salt
salt'.
After you fill the container, the salt indicator light can stay on for some hours. This
does not have an unwanted effect on the operation of the appliance.
1) It comes on when it is necessary to fill the rinse aid container. Refer to 'Use of
Rinse aid
detergent and rinse aid'.
End-of-pro- It comes on when the washing programme is completed.
gramme
1) When the salt and/or rinse aid containers are empty, the related indicator lights do not come on while a washing
programme operates.
Display
The display shows:
• The electronic adjustment of the level of
the water softener.
9
C
A B
3
1 2 4
Indicator lights
• A red light that flashes when there is a mal-
function.
If the appliance is installed in height, with
a flush kitchen furniture door, the optical
signal does not show.
5 6 7
• Activation/deactivation of the rinse aid dis-
penser (only with multitab function on).
• The number of the washing programme.
• Remaining time to the end of the washing
programme.
25
8