Thermo Sensor - Oregon Scientific RGR126 Bedienungsanleitung

. Remove screws and slide the cover off in an
upwards motion.
2. Insert the batteries (2 x UM-3 / AA), matching the
polarities (+ / -). Press RESET after each battery
change.
3. Remove the fibre tape.
To ensure a level plane:
Put a few drops of water on the cross at the base of the
funnel to check the horizontal level.
Downloaded from www.Manualslib.com
3
1
3
4
manuals search engine
Water will pool to the center of the cross when the rain
gauge is level.
If water remains on -4, the gauge is not horizontal.
If necessary, adjust the level using the screw.
NOTE For best results, ensure the base is horizontal to
allow maximum drainage of any collected

THERMO SENSOR

. Insert the batteries, matching the polarity (+ and -)
as shown in the battery compartment.
2
6
rain.E