Herunterladen Inhalt Inhalt Diese Seite drucken

Vermeiren Goliat Gebrauchsanweisung Seite 8

Schwerlastrollator
Vorschau ausblenden Andere Handbücher für Goliat:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 29
EN
NL
4.1.4 Mounting/Removing the backrest
Removing
1. Turn the locks on both sides of the
backrest to "open" position [A] by turning
the lever (10).
2. Slide the backrest upwards and remove.
Mounting
1. Make sure that the locks on both sides of
the backrest are placed to "open" position
[A].
2. Slide the backrest sides on the support
(11), as far down as possible.
3. Adjust the locks on both sides of the
backrest to "lock" position [B] by turning
the lever (10). Make sure that the
backrest is well secured into position
before sitting down!
4.2
Disassembly
CAUTION
Pay attention to the position of the brake
cables. Don't pull the handgrips too high
to prevent damage to the brake cable.
The disassembly of the rollator is conducted
in reverse order to the assembly:
1. Storage bag: Open snap fasteners (9) and
remove the bag.
10
10
11
Risk of damage
2. Cable clamp (7) (2x): Carefully pull from
the frame tube.
3. Handgrip with brake lever (2x): Press and
hold the spring button (5), and pull the
handgrip out of the frame.
4. Front and rear wheels (4x): Press and hold
the spring button (1), and pull the wheel
out of the frame.
4.3
Mounting the walking stick
holder (optional)
1. Click the cup (12) onto the provided
support on the lower rear frame.
2. Remove the screw (13) from the top frame
and place the screw that is delivered with
the walking stick holder in its place.
3. Place the clip with nut on the other side of
the screw, and tighten firmly.
13
4.4
Height adjustments
CAUTION
Always set the four wheels to the same
height.
• The rollator can be altered in height by
adjusting the handgrips (6 positions, in
steps of 25 mm)
• The seat can be altered in height by
adjusting the front wheels and rear
wheels (5 positions, in steps of 25 mm).
To adjust either of these:
1. Press and hold the spring button.
2. Slide the wheel or handgrip up/down in
the frame tube to the desired height, until
the spring button pops out of the
corresponding adjustment hole.
3. Make sure that the spring button is well
secured.
4
Goliat
2020-07
12
Risk of falling or
tipping over

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis