VONROC VC502AC Betriebsanleitung Seite 7

to blow dust and debris out of garages or of patios
and driveways.
The device is not suitable for commercial or indus-
trial use.
TECHNICAL SPECIFICATIONS
Model No.
Mains voltage
Mains frequency
Power input
Cable length
Protection category
Suction force
Container capacity approx.
Useful volume approx.
Filter - dry
Filter - wet
Hose system
Diameter intake port (19 Fig. D) Ø44mm
Recommended dust bag
Weight (incl. all accessories)
approx.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-4.
1. On/Off switch
2. Carrying handle
3. Vacuum port
4. Blowing port
5. Castor wheels
6. Locking clamp
7. Power cord storage
8. Tubes and nozzles storage
9. Container
10. Top section
11. Hose
12. Handle
13. Suction tubes
14. Floor nozzle
15. 2 in 1 nozzle
16. Dust collection bag
17. Cloth filter
18. Foam filter
WWW.VONROC.COM
VC502AC
220-240 V~
50-60 Hz
1000W
5m
IPX4
16 kPA, 1.5 m3/min
12 L
5 L
Cloth filter
Foam filter
Ø32mm
VC802AA
3.6kg
19. Intake port
20. Float
21. Filter cage
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
1. Press the 4 steering castors (5) on the con-
tainer (9) and tighten the screws as shown in
Fig. B. Make sure the steering castors (5) are
securely fastened.
2. Assemble the vacuum port (3) on the container
(9) and tighten the screws as shown in Fig. B.
3. Fit the filter. Ensure to mount the correct filter,
depending on the application:
• For dry vacuum cleaning, carefully slide
the cloth filter (17) over the filter cage (21)
making sure the entire cage (21) is covered
as shown in Fig. C-1.
• For wet vacuum cleaning, carefully slide
the foam filter (18) over the filter cage (21)
making sure the entire cage (21) is covered
as shown in Fig. C-2.
4. Place the top section (10) on the container (9)
as shown in Fig. E.
5. Connect the suction hose (11).
• For vacuuming (Fig. F-1), connect the suc-
tion hose (11) to the vacuum port (3).
• For blowing (Fig. F-2), connect the suction
hose (11) to the blowing port (4).
6. One or more suction tubes (13) can be fit to the
handle (12) to extend it (fig. A).
7. Connect the desired nozzle to the handle or
suction tubes (13).
Floor nozzle (14)
The floor nozzle is designed for domestic wet and
dry vacuuming in, for example, the house, work
room, or garage.
2 in 1 nozzle (15)
The crevice nozzle is designed for domestic wet
and dry vacuuming, edges and other areas that
are difficult to access. The brush is designed to
vacuuming solids from small areas.
EN
7