Risk of damage
NOTICE
If the appliance has been transported
horizontally, lubricant from the com-
pressor may get into the cooling circuit.
Do not tilt the appliance more than
■
45° or lay it on its side.
Allow the cooling unit to stand up-
■
right for two hours before start-up.
The lubricant will fl ow back into the
compressor during this time.
Improper handling of the appliance
can lead to damage to property.
Do not use the door to pull or lift the
■
appliance.
The appliance must only be placed
■
on a level and fi rm surface. The sur-
face must be strong enough to sup-
port the appliance's weight when ful-
ly laden.
Do not operate the appliance near
■
sinks, taps or containers fi lled with
liquids such as vases, aquariums, etc.
Make sure that the appliance does
not get wet.
The maximum load of 14 bottles per
■
bottle shelf must not be exceeded.
Do not use sharp or pointed objects
■
to unpack it.
Do not use any electrical parts inside
■
the appliance that do not conform to
the manufacturer's recommended
design.
Do not use mechanical devices or oth-
■
er means to accelerate the defrost-
ing process, other than those recom-
mended by the manufacturer.
When cleaning, please note:
■
Safety
Never use harsh, granular, soda,
–
acid, solvent-based or abrasive
cleaners. These attack the plastic
surfaces. All-purpose cleaners with
a neutral pH are recommended.
Door seals and plastic parts are
–
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
Do not clean the appliance parts in
–
the dishwasher.
Use only soft cloths for cleaning.
–
Wait 5 minutes after switching off.
■
Only then switch the appliance on
again.
Page EN-9