Atlas Copco G2417-S250 Bedienungsanleitung Seite 10

Operation
WARNING Failure to follow correct working practices can result in se-
rious injury or death
Ensure that the workpiece is properly supported
►
Maintain a balanced body position and firm footing
►
React quickly to excessive vibration due to damaged, or improperly
►
mounted insert tool
Observe that stored compressed air in the hose may cause an accidental
►
start
Release control device if the energy supply should fail
►
WARNING Electric shock
Should the product come in contact with electric circuits or other electrical
power sources, there is a risk of serious injury or death.
Never work near electric circuits or other electrical power sources
►
Make sure there are no hidden electric circuits in your working area
►
Personal protective equipment
The personal protective equipment must conform to the applicable health and
safety regulations.
Always wear the following personal protection:
• Safety helmet
• Hearing protection
• Safety goggles with side protection
• Protective gloves
• Safety footwear
Drugs, alcohol and medication
Drugs, alcohol and medication may impair your judgement and powers of con-
centration.
WARNING Poor reactions and incorrect assessments can lead to serious
accidents or death
Never operate the product when you are under the influence of drugs, al-
►
cohol or medication
Prevent other people from using the product if they are under the influ-
►
ence of drugs, alcohol or medication
Operation instructions
WARNING Air under pressure can cause serious injury
Always shut off air supply, drain hose of air pressure and disconnect tool
►
from air supply when not in use, before making any adjustments to the
machine, e.g. changing accessories, or when making repairs
WARNING Wrong insert tool can burst and cause serious injury or
death
Use insert tool with max operating speed higher or equal to the airgrinder
►
speed
Do not use other insert tool than specified by the manufacturer (no cut-
►
ting off wheels or router bits).
10
EN
© Atlas Copco Industrial Technique AB - 9836 9905
G2417-S250