Bauknecht BFP 5O41 PLT X Gebrauchsanweisung Seite 5

1. Open the dispenser B by pressing and pulling up the tab on the lid.
2. Carefully introduce the rinse aid as far as the maximum (110 ml)
reference notch of the filling space A - avoid spilling it.
If this happens, clean the spill immediately with a dry cloth.
3. Press the lid down until you hear a click to close it.
4. Confirm operation by pressing „OK" button.
NEVER pour the rinse aid directly into the tub.
Setting rinse aid level
(not necessary when using tablets/capsules)
The rinse aid dosage can be adjusted to the detergent used. The lower
the setting, the less rinse aid is dispensed. The factory setting is for (5)
level.
To change, follow instructions in section "SETTINGS / MENU".
7. Open tap operation
OPEN TAP
OPERATION
OPEN THE
OK = DONE
WATER TAP
OK = DONE
Check water tap is open. If closed, open it then confirm by pressing
„OK" button.
ADDING A DETERGENT
Usage of detergent not designed for dishwashers may
cause malfunction or damage to the appliance.
To achieve the best washing and drying results, the combined use of
detergent, rinse aid liquid and refined salt is required.
We recommend using detergents that do not contain phosphates or
chlorine, as these products are harmful to the environment.
Good washing results also depend on the correct amount of deter-
gent being used.
Exceeding the stated amount does not result in a more effective wash
and increases environmental pollution.
The amount can be adjusted to the soil level. In the case of normally
soiled items, use approximately either 35g (powder detergent) or
35ml (liquid detergent) and additional tea spoon of detergent directly
inside the tub. If tablets are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed with water
before being placed in the dishwasher, reduce the amount of deter-
gent used accordingly (minimum 25 g/ml) e.g. skip the powder/gel
putted inside the tub.
8. First cycle operation
FIRST CYCLE
OPERATION
REMEMBER TO RUN THE
OK = EXIT
INTENSIVE CYCLE
OK = EXIT
WITH EMPTY BASKETS
OK = EXIT
TO COMPLETE
OK = EXIT
THE FIRST SET UP
OK = EXIT
After this process the appliance is ready for normal use.
To open the detergent dispenser, press
button C. Introduce the detergent into
the dry dispenser D only. Place the
amount of detergent for pre-washing
directly inside the tub.
1. When measuring out the detergent
refer to the mentioned earlier infor-
mation to add the proper quantity.
Inside the dispenser D there are
indications to help the detergent
dosing.
2. Remove detergent residues from the edges of the dispenser and
close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until the
closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the program.
If you are using a All-in-one detergents, we recommend that you add
salt in any case, especially if the water is hard or very hard (follow the
instructions given on the packaging).
Before normal use of appliance it is
recommended to run Intensive cyc-
le first, to calibrate the appliance.
Insert a detergent into dispenser
chamber D (see below), then press
„OK" button.
Intensive cycle will be selected
automaticly. Press „START/PAUSE"
button.
This first cycle can be up to 20
minutes longer as a result of the
automatic calibration process.
D
C
EN
5