Retracting The Machine; Performing A Test Run - HOLZMANN-MASCHINEN ED1000N Betriebsanleitung

18.2

Retracting the machine

Never shift the gears of the machine while the machine is in operation and make sure
that both the shift lever tapping (lock nut) and the engaging lever cross feed -
longitudinal feed are disengaged before putting the machine into operation!
Otherwise the carriage may be pushed forward into the chuck or tailstock and cause
serious damage.
Before starting the machine, make sure that you have followed all assembly and
adjustment instructions, that you have read the instructions and that you are familiar
with the various functions and safety features of this machine. Disregarding this
warning may result in serious injury or even death!
After assembly is complete, test the machine to ensure that it is functioning properly and ready
for regular operation. This is done without a clamped workpiece. Perform the test as described
below.
18.2.1

Performing a test run

1. Make sure that you have understood the safety instructions in this manual and that all
other assembly steps have been completed.
2. Make sure that the necessary operating liquids (gear oil, etc.) have been filled up.
3. Make sure that the chuck is correctly fastened.
4. Make sure that all tools and objects used during setup are removed from the machine.
5. Release the shift lever tapping (lock nut) (O) and the engaging lever cross feed -
longitudinal feed (K).
6. Turn the Emergency Stop (F) clockwise until it pops out.
7. Move the shift lever feed direction (A) to the disengaged centre position.
8. Set the machine to the lowest speed.
9. Connect the machine with the CEE-plug to the power supply.
10. Press the shift lever rotating direction (N) to start the lathe. The spindle rotates at
65 min -1. When properly operated, the machine runs smoothly with little or no vibration or
friction.
11. Move the shift lever rotating direction (N) to the center position and press the Emergency
Stop (F).
12. Without resetting the Emergency Stop (F), move the shift lever rotating direction (N)
down. The machine must not start.
If this is the case, the safety function of the Emergency Stop (F), is guaranteed. Continue
with the next step.
However, if the machine starts with the Emergency Stop (F) pressed in, disconnect the
power supply to the machine immediately. The Emergency Stop (F) does not function
properly. In this case contact the customer service.
13. Turn the Emergency Stop (F), clockwise until it pops out.
14. Make sure that the indicator light (C) is working.
The retraction must be carried out at the lowest spindle speed. Let the machine run at this speed
for about 1 hour. Pay attention to any abnormalities and/or irregularities, such as unusual noises,
unbalance, etc. If everything is OK, gradually increase the speed. The highest speeds may only
be reached after 10 hours of operation.
If unusual noises or vibrations occur during the test run, stop the machine immediately and read
the Troubleshooting section. If you cannot find a remedy, contact your specialty retailer or
customer service.
HOLZMANN MASCHINEN GmbH
N O T I C E
W A R N I N G
www.holzmann-maschinen.at
OPERATION
58
ED1000N | ED1000NDIG