FITFIU FITNESS MC-500 Betriebsanleitung Seite 64

Problem
Running belt tension not even
Belt is not centred.
across the rear roller.
Display shows
The safety tether is not in place.
""E00" or "E07"
Display shows Communication problem between
""E01" or "E13" drive unit and console detected.
Display shows
"E02" or "E06" or Drive unit/motor problem detected.
"E10"
Display shows
Speed sensor problem detected.
"E03"
Display shows
Tilted belt, motor problem detected.
"E04"
Display shows
Electrical protection tripped.
"E05"
Display shows
Unit control problem detected.
"E08"
Display shows
Stability problem detected
"E09"
Display shows Electrical power supply protection
"E11" or "E14" tripped.
Equipment
Surface not flat.
unsteady.
This equipment is designed with user safety as a priority. In the event of electrical failure, the equipment will shut off
automatically to prevent injury and damage to the unit. If you encounter unusual behaviour from the equipment, turn
the power switch off and on to reset the equipment. This should ready the equipment for normal operation again. If
after you have reset the equipment that it is still not operational, call an authorised service centre or technician for
servicing as required.
Cause
Adjust belt alignment.
Place safety tether in correct location.
Check connections between console and drive unit. If
he connectors or wiring is damaged, replace it.
Check mains electrical supply is to specifications.
Check drive unit and motor connections. If the motor is
damaged, replace it.
Check all connections. If the motor or the control unit
is damaged, replace it.
Check all connections. If the motor or the control unit is
damaged, replace it.
Check mains electrical supply is to specifications.
Ensure that drive belt is not caught or is unable to
rotate due to obstruction. Check all connections. Check
for motor or control circuitry fault (often indicated by a
burning smell) and replace parts as required.
Check all connections. If the control unit is damaged,
replace it.
Make sure the machine is correctly unfolded and placed
on a flat and levelled surface. Check all Display shows
Display shows "E09" "E09"connections. If the control unit
is damaged, replace it.
Check mains electrical supply is to specifications.
Check all connections. Check for motor or control
circuitry fault (often indicated by a burning smell) and
replace parts as required.
Set-up equipment on a flat surface. If applicable,
rotate feet under front of machine to move up or down
as needed so that the equipment is steady.
64
Solution