Assembling The Product - FLORABEST HG03610A Montage-Und Sicherheitshinweise

Verify that the scope of delivery
is complete.
The scope of delivery does not
include ring bolts for assembly.
Ask the retailer about ring bolts
suitable for the respective wall
structure.
Do not leave unattended in the
built-up state.
The sun shade sail must be con-
structed so that water can run
off.
Dismantling of the product at
expected wind speeds of more
than 40 km/h (fresh wind, larger
branches and trees move, and
the wind is clearly audible).
Assembling the
product
Note: Remove all packaging
material from the product.
Figure A:
Spread out the sun shade sail
in front of the assembly site and
use a measuring tape to transfer
the length of the sun shade sail
to the wall on which it will
1
be mounted.
Mark the positions for the ring
bolts (not included in the scope
of delivery) on the wall and
mount these.
Tighten the ring bolts using a
pair of pliers.
Figure B:
Cut the tensioning cable
several parts. Ensure that the
length of the individual parts is
enough to be able to knot them.
Figure C:
Now thread one end of the ten-
sioning cable parts through a
loop of the sun shade sail
Tie the tensioning cable parts
into a tight knot.
Thread the other end of the ten-
sioning cable parts through a
spring
Attach a snap hook
other end of each spring
Figure D:
Now hang the sun shade sail
from the wall. To do so, con-
1
1
nect the individual ring bolts to
a snap hook
and tie a tight knot.
3
to the
4
.
4
into
2
.
1
.
3
GB/IE 17