Auxiliary Handle - Worx Professional WU343 Handbuch

speed switch (5) that delivers higher speeds with increased trigger
pressure - speed is controlled by varying the pressure applied to the switch.
3
SWITCH LOCK-ON BUTTON
Depress the on/off switch (5) then the lock on button (4); release the
on/off switch first and the lock-on button second. Your switch is now
locked on for continuous use. To switch off your tool just depress and
release the on/off switch.
4

AUXILIARY HANDLE

Slide the handle onto the hammer and rotate to the desired working
position. To clamp the auxiliary handle rotates the handle clockwise. To
loosen the auxiliary handle rotate the handle anti-clockwise (See B).
Warning: Always use the auxiliary handle.
5
FORWARD AND REVERSE ROTATION CONTROL (WU344
WU344.1)
With the drill pointing away from you, push the forward/reverse-lever
(6) to the left " "for forward rotation. Push the forward/reverse-
lever (6) to the right for reverse rotation "
Warning: Never change the direction of rotation while the
tool is rotating, wait until it has stopped.
6 ADJUSTABLE DEPTH GAUGE
Fit the drill bit into the chuck. Loosen the depth gauge by rotating
the handle anti-clockwise. Slide the depth gauge until the distance
between the depth gauge end and the drill bit end is equal to the
depth of hole/screw you wish to make. Then clamp the depth gauge
by rotating the handle clockwise.
".
8
7
FUNCTION MODE SELECTION
The operation of the gearbox for each application is set with the
function mode selection switch (7). To change between functions,
depress the unlocking button (10) and rotate the selector to the
desired operating mode.
For simultaneous drilling and impacting of
concrete or masonry, choose the Hammer
drilling position.
For drilling into steel, wood and plastics
choose the Rotary drilling position.
Warning: The operating mode selector switch may be
actuated only at a standstill.