Mounting And Removing Flat Panel Display - PEERLESS Mounts ST670 Installation Und Montage

Mounting and Removing Flat Panel Display

WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the fl at panel display.
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
• Be careful not to pinch fi ngers when pushing display from
the bottom.
Tension Adjustment of Ratchet Handle: Adjust
3
tension in tilt brackets (BB & CC) by rotating ratchet
handle. NOTE: If obstruction prevents ratchet handle
from rotating, pull handle out while turning will allow
handle to reposition without tightening. Release and
turn handle to tighten or loosen.
Mounting Display: Ratchet handle must be in the
up or down position or interference will occur while
hooking tilt brackets to wall plate (AA). Slowly hook tilt
brackets (BB & CC) onto wall plate (AA) and swing
display down as shown in fi g. 3.1. Tilt bracket hooks
must fully engage wall plate as shown in detail 1.
Using phillips screw driver or security allen wrench
(FF), turn safety/security screws on tilt brackets (BB
& CC) clockwise till screw tip securely contacts wall
plate as shown in cross section.
Display Adjustment: Display can be adjusted
horizontally by loosening safety/security screws on tilt
brackets (BB & CC) three full turns. Adjust display as
shown in fi gure 3.2. Tighten safety/security screws on
tilt brackets till screw tip securely contacts wall plate
as shown in cross section.
Removing Display: To remove display from mount,
loosen safety screws, swing display away from mount,
and lift display off of mount.
Adjusting the Tilt Angle of the Flat Panel Display
For preset tilt angles use Increlok™ and for custom
4
tilt angle use ratchet handle.
INCRELOK™: The display can be locked into a
pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
locator hole to fi nd tilt position hole and tilt display to
align holes. Tighten IncreLok™ tilt locking screws on
both tilt brackets to lock tilt as shown in detail 2.
Ratchet Handle: Loosen ratchet handle (refer to
step 3 for tension adjustment of handle). Push or pull
from top or bottom of display to adjust tilt as shown
in fi gure 4.1. The tilt can be adjusted to a maximum
of 15° forward or 5° backward.
AA
DETAIL 1
AA
SAFETY/
SECURITY
SCREW
CROSS SECTION
IncreLok™
TILT LOCKING
SCREW
TILT
POSITION
HOLES
DETAIL 2
9 of 38
ISSUED: 11-07-07 SHEET #: 202-9244-6 04-05-11
All other brand and product names are trademarks or registered trademarks of their respective owners.
BB,CC
RATCHET
HANDLE
BB,CC
fi g. 3.1
fi g. 3.2
LOCATOR
HOLE
RATCHET
HANDLE
fi g. 4.1
© 2011, Peerless Industries, Inc. All rights reserved.
Peerless Industries, Inc.
2300 White Oak Circle
Aurora, Il 60502
www.peerlessmounts.com