Herunterladen Inhalt Inhalt Diese Seite drucken

Storage Notes - Chauvet Professional WELL STX 180 Schnellanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

EN
Battery Charge Notes
This product is equipped with a built-in rechargeable lithium ion battery.
Avoid depleting the battery below 10%.
For best results, charge the battery in a temperature between 32 °F (0 °C) and 95 °F (35 °C).
When charging the battery, keep the product at least 1 m from any open flame or hot plate.
If the battery is completely discharged, the device cannot be turned on immediately when the charger is
connected. allow a depleted battery to charge for a few minutes before turning on the device.
While charging, the device may heat up. This is normal and should not affect the device's lifespan or performance.
If the battery gets hotter than usual, the charger may stop charging.
When charging the battery, keep the charging case's cover open.
Always charge the battery with the product in an upright position.
Do not charge the battery for more than 24 hours.
CAUTION: The product must be turned off before placing it in the charging case.

Storage Notes

Recharge the battery to full capacity before storing the product.
Store charged product(s) in a dry environment, away from direct sunlight.
Mounting
Before mounting this product, read the
magnetic mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of
mounting clamps, go to http://trusst.com/products.
Floor stand
The WELL STX 180 comes with a floor stand that can be used for surface installation.
Mounting diagram
Hanging eye bolt
Control Panel Description
Button
Function
<MENU>
Exits from the current menu or function
<ENTER>
Enables the currently displayed menu or sets the currently selected value into the selected function
<UP>
Navigates upwards through the menu list and increases the numeric value when in a function
<DOWN>
Navigates downwards through the menu list and decreases the numeric value when in a function
Passcode
After being prompted, enter the following passcode by pressing: <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>.
This passcode cannot be changed and must be used whenever prompted.
3
QUICK REFERENCE GUIDE
Safety
Notes. Use at least one mounting point per product. Make sure the
Overhead Mounting
Safety cable
Magnetic clamp (2x)
Floor Stand Installation
Floor stand
WELL STX 180 QRG Rev. 4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis