Herunterladen Inhalt Inhalt Diese Seite drucken

Installation Instructions - IBIZA LIGHT STROBE-75 Bedienungsanleitung

Power strobe 75w
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

INSTALLATION INSTRUCTIONS

Installing or replacing the lamps
Before replacing the lamps let the lamps cool down, because during operation, the lamps can reach temperatures of
up to 700°C. Wait at least 10 minutes after use before opening the housing.
During the installation of the lamp do not touch the glass bulb bare handed. Always use a cloth to handle the lamp
during insertion and removal.
Do not install lamps with a higher wattage. They generate higher temperatures than for which the device was
designed for.
For the installation, you need a 75W strobe lamp.
Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that
their effectiveness is impaired, for example by cracks or deep scratches.
The lamp shall be changed if it has become damaged or thermally deformed
Procedure:
Remove the screw on the front, holding the glass pane
Carefully remove the glass pane by making a counter-clockwise movement, making sure it doesn't get damaged
Remove the old lamp carefully
Place the new lamp
Close the glass pane by making a clockwise movement
Fasten the screw
CAUTION:
1. Do not operate this device with open cover!
2. The glass pane has to be replaced when it is damaged!
3. The lamp has to be replaced when it is damaged or deformed!
4. Only install the lamp with the device unplugged from the mains!
MOUNTING
Orientation
This fixture may be mounted in a 90°degree angle only, provided there is adequate room for ventilation
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable "C" or "O" type clamp.
Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position,
retighten both knobs.
When selecting installation location, take into consideration lamp replacement access and routine maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or
restricted ventilation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar qualified person in order to avoid a hazard.
Fuse replacement:
Warnings: Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With your hands, unscrew the fuse holder from its housing, remove the damaged fuse from its holder and replace
with exactly the same type of fuse. Screw the fuse holder back in its place and reconnect power.
© Copyright LOTRONIC 2011
STROBE75
Page 3

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

15-1045

Inhaltsverzeichnis