Technics SU-R1000 Bedienungsanleitung Seite 18

Operations
Using this unit as power amplifier
You can connect the AV receiver, control amplifier, etc. with analogue audio cable (not
supplied) to this unit and use this unit as power amplifier.
Set the volume of the AV receiver,
control amplifier, etc. to minimum before
connecting.
While using this unit as power amplifier,
the volume adjustment with this unit is
disabled. Adjust the volume little by little
with the connected device.
Do not input the audio signal from REC
OUT/PRE OUT terminals to the MAIN IN
terminals of this unit. Doing so may cause
malfunction.
Analogue audio cable
(not supplied)
PRE OUT
1 Disconnect the AC mains lead.
2 Connect this unit and AV receiver,
control amplifier, etc. after minimising
the volume of the device.
3 Connect the AC mains lead to this
unit. ( 12)
4 Press the unit on/off button to the
[ ] position.
5 Press [SETUP].
6 Press [ ], [ ] repeatedly to select
"MAIN IN" and then press [OK].
7 Press [ ], [ ] to select "On" and press
[OK].
18
(18)
AV receiver, control
amplifier, etc.
8 Confirm the displayed message and
press [OK].
9 Press [ ], [ ] to select "Yes" and then
press [OK].
10 Start playback on the connected
device.
Note
• It is not possible to adjust the volume with this
unit.
• Sound is not output from headphones jack and
REC OUT/PRE OUT terminals.
Minimising sound distortion
If sound distortion occurs, setting the attenuator
to "On" may improve the sound quality.
• The factory default is "Off".
1 Press [MENU].
2 Press [ ], [ ] repeatedly to select
"Attenuator" and then press [OK].
3 Press [ ], [ ] to select "On" and then
press [OK].